labstore100[123] are old WMCS storage servers, that were replaced (refreshed) by labstore100[45] with T161345 and cloudstore100[89] with T186931. They also have disk shelves connected to them, and these should be decom'ed as well.
Disk Wipe Notes: Please note these are HIGH capacity systems, have their own internal disks, and each host has 2-3 disk arrays.
***labstore1001:***
Steps for service owner:
[x] - all system services confirmed offline from production use
[x] - set all icinga checks to maint mode/disabled while reclaim/decommmission takes place.
[x] - remove system from all lvs/pybal active configuration
[x] - any service group puppet/hiera/dsh config removed
[x] - remove site.pp, replace with role(spare::system)
[x] - unassign service owner from this task, check off completed steps, and assign to @robh for followup on below steps.
Steps for DC-Ops:
The following steps cannot be interrupted, as it will leave the system in an unfinished state.
**Start non-interrupt steps:**
[x] - disable puppet on host
[x] - power down host
[x] - update netbox status to Inventory (if decom) or Planned (if spare)
[x] - disable switch port
[x] - switch port assignment noted on this task (for later removal)
[x] - remove all remaining puppet references (include role::spare)
[x] - remove production dns entries
[x] - puppet node clean, puppet node deactivate (handled by wmf-decommission-host)
[x] - remove dbmonitor entries on neodymium/sarin: sudo curl -X DELETE https://debmonitor.discovery.wmnet/hosts/${HOST_FQDN} --cert /etc/debmonitor/ssl/cert.pem --key /etc/debmonitor/ssl/server.key (handled by wmf-decommission-host)
[x] - host set to 'decommissioning' in netbox.
**End non-interrupt steps.**
[] - system disks wiped (by onsite)
[] - disk shelf disks wiped (by onsite)
[] - system unracked and decommissioned (by onsite), update status in netbox to offline
[] - switch port configration removed from switch once system is unracked.
[] - add system to decommission tracking google sheet
[] - mgmt dns entries removed.
***labstore1002:***
Steps for service owner:
[x] - all system services confirmed offline from production use
[x] - set all icinga checks to maint mode/disabled while reclaim/decommmission takes place.
[x] - remove system from all lvs/pybal active configuration
[x] - any service group puppet/hiera/dsh config removed
[x] - remove site.pp, replace with role(spare::system)
[x] - unassign service owner from this task, check off completed steps, and assign to @robh for followup on below steps.
Steps for DC-Ops:
The following steps cannot be interrupted, as it will leave the system in an unfinished state.
**Start non-interrupt steps:**
[x] - disable puppet on host
[x] - power down host
[x] - update netbox status to Inventory (if decom) or Planned (if spare)
[x] - disable switch port
[x] - switch port assignment noted on this task (for later removal)
[x] - remove all remaining puppet references (include role::spare)
[x] - remove production dns entries
[x] - puppet node clean, puppet node deactivate (handled by wmf-decommission-host)
[x] - remove dbmonitor entries on neodymium/sarin: sudo curl -X DELETE https://debmonitor.discovery.wmnet/hosts/${HOST_FQDN} --cert /etc/debmonitor/ssl/cert.pem --key /etc/debmonitor/ssl/server.key (handled by wmf-decommission-host)
[x] - host set to 'decommissioning' in netbox.
**End non-interrupt steps.**
[] - system disks wiped (by onsite)
[] - disk shelf disks wiped (by onsite)
[] - system unracked and decommissioned (by onsite), update status in netbox to offline
[] - switch port configration removed from switch once system is unracked.
[] - add system to decommission tracking google sheet
[] - mgmt dns entries removed.
***labstore1003:***
Steps for service owner:
[x] - all system services confirmed offline from production use
[x] - set all icinga checks to maint mode/disabled while reclaim/decommmission takes place.
[x] - remove system from all lvs/pybal active configuration
[x] - any service group puppet/hiera/dsh config removed
[x] - remove site.pp, replace with role(spare::system)
[x] - unassign service owner from this task, check off completed steps, and assign to @robh for followup on below steps.
Steps for DC-Ops:
The following steps cannot be interrupted, as it will leave the system in an unfinished state.
**Start non-interrupt steps:**
[x] - disable puppet on host
[x] - power down host
[x] - update netbox status to Inventory (if decom) or Planned (if spare)
[x] - disable switch port
[x] - switch port assignment noted on this task (for later removal)
[x] - remove all remaining puppet references (include role::spare)
[x] - remove production dns entries
[x] - puppet node clean, puppet node deactivate (handled by wmf-decommission-host)
[x] - remove dbmonitor entries on neodymium/sarin: sudo curl -X DELETE https://debmonitor.discovery.wmnet/hosts/${HOST_FQDN} --cert /etc/debmonitor/ssl/cert.pem --key /etc/debmonitor/ssl/server.key (handled by wmf-decommission-host)
[x] - host set to 'decommissioning' in netbox.
**End non-interrupt steps.**
[x] - system disks wiped (by onsite)
[x] - disk shelf disks wiped (by onsite)
[x] - system unracked and decommissioned (by onsite), update status in netbox to offline
[] - switch port configration removed from switch once system is unracked.
[x] - add system to decommission tracking google sheet
[] - mgmt dns entries removed.
**labstore-spare-array:**
[] - locate labstore-spare-array https://netbox.wikimedia.org/dcim/devices/1405/
[] - ensure no disks are in it, remove from racks and stack in decom pile
[] - update netbox to show offline/unracked, remove rack info **and record their asset tags**
[] - add to decom tracking sheet.