xAll the disk were securely wiped and server reset to server defaults

All the disk were securely wiped and server reset to server defaults

Removing ops-eqiad tag and assigning to Andrew for install. please add tag back if there are any h/w issues

I created a procurement task T221470

Created a procurement ticket T221470

Removing ops-eqiad tag and assigning to @Andrew

Removing ops-eqiad tag and assigning to @Andrew

Removing ops-eqiad tag and assigning to @Andrew

Removing ops-eqiad tag and assigning to @Andrew

Removing the ops-eqiad tag and assigning to @Andrew

removing ops-eqiad tag and assigning to @Andrew

@Andrew even after the updates by rob I am not able to get to the raid utility. Do you want to keep it as-is without having the 2 spare disks?

This server is refusing to allow me to access the raid configuration. It has the old config now...I think @RobH may know how to update BIOS...not sure if that will help. I did run the service pack and the ILO is up to date.

done

The cable looks good and appears to be passing traffic, I have a link at the server and shows up on the switch
xe-2/0/8 up up ms-be1044

@Andrew All Yours!

MAC: F0:92:1C:05:2A:60

@fgiunchedi do you want to power off unplug and power on...that will clear the issue

raid updated

raid updated

raid updated

MAC F0:92:1C:05:4A:98

MAC F0:92:1C:05:F5:20

This is ready for you @andrewbogott

MAC F0:92:1C:05:F5:70

@andrewbogott same as cloudvirt1001/1002.

@andrewbogott: all the on-site work is finished, if you can do raid cfg and dhcp file then it should work

@andrewbogott: all the on-site work is finished, if you can do raid cfg and dhcp file then it should work

production ports

Great! I will make all the changes locally if you can update your side.

@Jgreen I need an mgmt IP for this.... I apologize but I don't recall any of the fundraising mgmt info.

@ayounsi lvs1013 and 1014 on-site work has been completed. I did not add the LVS vlan....I will leave that to you. I still need to run the cross-connects but the servers can be installed.

@Marostegui @RobH these are racked and all on-site work is completed.

Completed

Completed

@AndrewBogott Is this re-imaged yet? Can we resolve this task? Thanks

Completed

The server is out of warranty, can we get a replacement or use a spare replacement?

Resolving for now

Cable was loose, fixed

I replaced both DIMM A1 and B1 since I had previously ordered one for mw1264 that I did not need. Please add back to but I have a feeling that a CPU may be bad. Let's leave this open for a week and see if an errors return.

@RobH, @Marostegui or @jcrespo These servers are finished with the on-site specific tasks. All yours to finish

@Joe Good news is I have already ordered the DIMM from the previous failure
and it's on-site. I can do this tomorrow afternoon (my time) if you can
depool it then.

I replaced the cables on 1024 but still do not get a link. I see 1018 is working now...was a change there made?